NASTF Information Requests

Tracking: 352 Status: Closed - Requester Satisfied
State: CO Name: Rnald
Category of Request: Reprogramming Manufacturer: 2006 FORD E350

Inquiry
Have you checked the OEM website?
Yes
Description of Repair unable to perform
Ficm program after installing
Description of Information not available
Module security access not granted when it tried to program PCM after Ficm
Description of steps taken to obtain information (help/contact function on website, websites, etc.)
Ease help, Emailed Motorcraft help
Other Comments or Concerns
I updated to Ford 70.01 software. The was no Pats on the menu. Also there is no as built button on the menu
Notes
Mary Hutchinson - 12/10/2010
Mr. Fisk sent an e-mail on the night of December 9 stating that Ford had contacted him in response to his help request; the following is the e-mail that he sent: I will try this. Here is this is their resposes. This is a known concern.To resolve it, at the point that FMP instructs you to cycle the key off/on multiple times, ignore the command, leave the ignition key in the run position and press the tick for each key cycle command. After the last key cycle command, FMP will start the module programming. Thankyou Ronald Fisk
Home